李金凤,唐祯安,汪家奇.用于单片集成真空传感器的SAR型ADC设计[J].,2009,(6):958-963 |
用于单片集成真空传感器的SAR型ADC设计 |
Successive approximation register ADC for monolithic vacuum sensor |
|
DOI:10.7511/dllgxb200906031 |
中文关键词: 逐次逼近 A/D转换器 低功耗 CMOS 单片集成真空传感器 |
英文关键词: successive approximation analog-to-digital converter ADC low power dissipation CMOS monolithic vacuum sensor |
基金项目:国家自然科学基金资助项目90607003 |
|
摘要点击次数: 1283 |
全文下载次数: 857 |
中文摘要: |
设计了一款适用于单芯片集成真空传感器的10位SAR型A/D转换器.轨至轨比较器通过并联两个互补的子比较器实现.信号采样时,比较器进行失调消除,提高电路的转换精度.电路采用0.5 μm 2P3M 标准CMOS工艺制作.系统时钟频率为20 MHz,输入电压范围为 0~3 V. 在1.25 MS/s采样率和4.6 kHz信号输入频率下,电路的信噪比为56.4 dB,无杂散动态范围为69.2 dB.芯片面积为2 mm 2.3 V电源电压供电时,功耗为3.1 mW.其性能已达到高线性度和低功耗的设计要求. |
英文摘要: |
A 10-bit successive approximation register analog-to-digital converter (ADC) is presented for monolithic vacuum sensor. Rail to rail comparator is achieved by paralleling two complementary comparators. Offset cancellation circuit is included to improve the precision of the ADC. The circuit is fabricated in a 0.5 μm 2P3M standard CMOS process. The system clock frequency is 20 MHz and the input voltage changes from 0 to 3 V. The effective chip area is 2 mm 2.The signal to noise and distortion ratio of 56.4 dB and the spurious-free dynamic range of 69.2 dB are achieved with 4.6 kHz sinusoid wave and 1.25 MS/s sample rate. The power dissipation is 3.1 mW at 3 V supply voltage. The proposed ADC meets the requirements of high linearity and low power dissipation. |
查看全文
查看/发表评论 下载PDF阅读器 |
关闭 |